Efficacy of autologous platelet concentrate products for alveolar preservation: A meta-analysis.

PURPOSE: The purpose of the study was to systematically evaluate the efficacy of autologous platelet concentrate products in the preservation of the alveolar ridge after tooth extraction through meta-analysis and provide a theoretical basis for the clinical application of autologous platelet concentrates to reduce alveolar bone resorption. METHODS: This study conducted a meta-analysis of clinical trials between 2013 and 2023, focusing on autologous platelet concentrate products (e.g., PRP, PRF, CGF, and PRCF) used for alveolar ridge preservation after tooth extraction. The analysis included 122 articles and 371 extraction sockets. All statistical analyses were performed using Review Manager version 5.4. RESULTS: Results indicate that these platelet concentrates effectively reduced changes in horizontal width 1 mm below the alveolar crest and vertical socket height. They also promoted a higher percentage of new bone formation in extraction sockets compared with control groups. However, they did not significantly prevent horizontal bone resorption at 3 and 5 mm below the alveolar crest. CONCLUSION: In conclusion, autologous platelet concentrates are useful for alveolar ridge preservation, but larger clinical studies are needed to confirm these findings due to the relatively small sample size in this study.

The non-viral vectors and main methods of loading siRNA onto the titanium implants and their application.

Surface modification of titanium implants by siRNA is quite efficient for improving implant osseointegration. Loading siRNA onto their surface is a crucial factor for siRNA-functionalized implants to realize their biological function. Direct binding of siRNA to implants has low siRNA binding and releasing rate, so usually it needs to be mediated by vectors. Polymeric, nonmaterial-mediated and lipid-based vectors are types of non-viral vectors which are commonly used for delivering siRNA. Three major methods of loading process, namely simple physical adsorption, layer-by-layer assembly and electrodeposition, are also summarized. A brief introduction, the basic principle and the general procedure of each method are included. The loading efficiency, which can be measured both qualitatively and quantitatively, together with gene knockdown efficiency, cytotoxicity assay and osteogenesis of the three methods are compared. A good many applications in osteogenesis have also been described in this review.